Modelo afectado

Esta información es para los siguientes modelos:

  • VPL-VW320
  • VPL-VW328

Update from v2.302:
-To solve the issue of irregular image which occurs with 4K signal input in HDR mode

Updating the System Software
Update from v.2.202 or later :
– Power off the projector.
– Make sure no other USB device is connected to the projector before starting the update.
– Insert the USB storage device containing the update folder into USB port of the projector.
– Power on the projector. The update process starts automatically.
– When the update is finished, the projector will turn off.
– Turn on the projector to complete the update process.

Update from v.2.003 or earlier:
Please read installation instructions before downloading.
CAUTION: During the update process, do not remove the USB device or turn off the projector.

1. Power off the projector.
2. Make sure no other USB device is connected to the projector before starting the update.
3. Insert the USB storage device containing the update folder into USB port of the projector.
4. Power on the projector.
5. Update process starts automatically for approximately 5 minutes. During the update, the ON/STANDBY indicator blinks green. Then, it blinks amber. It takes about 5 minutes to update.
6. Power on the projector.
7. Note: After the update, initial power on takes about 15 minutes to light a lamp. During this period, ON/STANDBY indicator blinks green. During the updating process, DO NOT unplug/power off the projector. Once the update is finished, refer to step 8.
8. After the above step, you will get an image from the projector.